Renard 24HC Parts Kit w/PCB

The Renard 24HC is on onboard SSR Renard Controller. It is fully adaptable for many supply voltages from 220VAC all the way down to 24VAC. The PCB is a professionally made, double sided and fully silk screened board. In the current configuration, each channel can handle up to 4A (with suitable heat sinks)and each side of the board is fused for 15A. The board power supply can be separated to the left and right side depending upon your needs. The kit consists of the following parts:

180 Ohm Resistor, 1/4 W, Axial R1-R24

680 Resistor, 1/4 W, Axial R25-R53

27K Resistor, 1/8 W, Axial R64,R65,R66

1K Resistor, 1/8 W, Axial R67,R68

120 Resistor, 1/8 W, Axial R61

1000 uF, 16V Radial-Lead Elect. Cap C8

0.1 uF Radial-lead Ceramic Capacitor C1-C5

10 uF, 16V Radial-Lead Elect. Cap C6-C7

Bridge Rectifier, 1A, 200V U8

Rectifiers Vr/50V Io/1A D7

4.3v 0.5w Zener D2

9.1v 0.5w Zener D1

T1 Red LED D3-D6

T1 Green LED D7

AMP Modular Jacks, Vertical PCB mount Comm In, Comm Out

14 Pin Low Profile IC Socket U3,U4,U5

MPCB Header 3-pin JP1-JP6

2-Pin Shunt JP1-JP6

Regulator, LDO, 5V, 1.5A U6

Heat Sink, TO-220 U6

RS485 Connectors U1,U2

Socket, 8 Pin U1,U2

Optoisolator U7

Socket, 6 pin U7, M1-M24

PIC16F688, Unprogrammed, DIP14, U3,U4,U5

Triacs 4 Amp 700 Volt T1-T24

MOC3023 M1-M24

Oscillator, 18.432 MHz, 5V, 8-DIP OSC

Transformer, 115V/6.3VAC, 1A TF1

Fuse, 5x20mm, 15A F1-F2

Clip, Fuse 5x20 F1-F2

Terminal, 2 Position, 90 deg

Terminal, 3 Position, 90 deg

Terminal, 3 Position, 45 deg

Terminal, 2 Position, 90 deg (for making 6 Position Terminals)

Renard 24HC PCB

The designations here are based on this document.